RKC Thermostat -Was sind die häufigsten Fehler bei Thermostaten?
Release-Zeit:2023-08-28 16:14:58
1, the power does not appear. This kind of problem first confirm whether the power supply is available and whether the power supply is matched with the power supply required by the thermostat, and then check whether the wiring is strong. The problem remains, then it is the problem of the thermostat itself.
2, there are manifestations, manipulation mistakes. This kind of problem should first look at the control wiring, and then consider the sensor and the actuator.
3, the temperature controller control temperature and practice temperature deviation. This kind of problem should be the PID parameter tuning problem, the need to set PID parameters from scratch.
4, heating for a period of time, the temperature has not changed, has been the ambient temperature. This kind of problem is actually a thermocouple problem, and its problem can easily lead to the temperature controller showing the ambient temperature.
5, the heating process, the temperature is getting lower and lower. There's a good chance the thermocouple's in reverse.
6, the temperature controller display and practice value is different. Such problems can be seen whether the wiring is loose, the sensor is damaged, and the type of sensor used does not match the type of sensor selected by the instrument.
-
202305-05
Delta-Wechselrichter langfristige Leerlaufpunkte für Aufmerksamkeit
After the frequency converter is used for more than half a year, if the equipment is to be run again, the chance of damage may be greatly increased because of the placing environment, the service life···
-
202302-15
Was Symptom hat die Fehlfunktion des WEINVIEW-Touchscreens auf dem Motherboard?
1. Das Motherboard kann Peripheriegeräte nicht erkennen / anzeigen.2. Die Peripheriegeräte funktionieren für einige Sekunden oder länger nicht mehr.3. Ein langsamer Start kann darauf hindeuten, da···
-
202308-18
Siemens SINAMICS G120 modularer Wechselrichter Vorteile
1. Modularer Aufbau schafft ein hohes Maß an Flexibilität zur Anpassung an zukünftige Anforderungen an AntriebslösungenDas Steuergerät kann durch Strom ersetzt werden (Hot Swap)Steckklemmen verwe···
-
202302-02
Mitsubishi PLC, wie man eine Hold-Schaltung schreibt
Mitsubishi PLC hat eine sehr verbreitete Schaltung - eine Stick-Schaltung. Persistenzschaltung bedeutet, dass, wenn der externe Eingangsschalter eine Taste ist, er am Ausgang haften kann, indem er die···
-
202306-09
ABB-Roboterprogramm Laufgeschwindigkeit langsame Reparaturschritte
1, prüfen Sie, ob das Programm logische Anweisungen enthält (oder andere Anweisungen, deren Ausführung keine Zeit in Anspruch nimmt), da solche Programme Ausführungsschleifen verursachen, wenn die···