Schneider PLC Schaltschrank Installation Verdrahtung Methode

(1) When placing signal cables with different properties into the same conduit, they must be isolated

② Try to avoid multiple power lines contained in the same catheter. If necessary, a partition shall be installed in the conduit and grounded.

(3) When wiring with wire tubes, do not place the wires of 1 circuit in different wire tubes because of the heat of wire tubes.

(4) In order not to make the power cable and signal cable mutual influence, do not parallel wiring.

⑤ If installed in the cabinet with high voltage equipment, because the noise will be induced, so as far as possible away from the high voltage, power system wiring Settings.

Installieren Sie die SPS mehr als 200 mm von der Stromleitung des Hochspannungskabels entfernt, oder stecken Sie das Hochspannungskabel und das Stromkabel in die Metallrohrverkabelung, und das Metallrohr gründlich D Erdung.